Healy Awards – Order Your Winter Sports Awards Today!

March 2015 - Winter Sports Awards

March 2015 - Hall of Fame

March 2015 - Fundraising Stickers

March 2015 - Budget Packs

Healy Awards – How to Replace a Broken Record (Replacement Text)

Did one of your athletes recently break a record on your Record Board from Healy Awards?  If so, these easy to read instructions will guide you through the process of updating your Record Board with the new record.

Step 1: Remove existing record or year with provided razor blade pulling the vinyl from the PVC Board.

Step 2: Clean the area with alcohol to remove any dust or debris before applying new record.

Step 3: Measure with ruler and center new record in the area.  Use two pieces of masking tape on each side to hold in place and create placement guides.

Step 4: Apply a masking hing in the middle of the record.

Step 5: Cut the tape from the side of the record leaving a piece on the board to use as a guide.  Remove backing up to hinge exposing vinyl record.

Step 6: Use tape guidelines to align position of record.  Using firm pressure, squeegee (plastic credit card or provided razor blade) over first half of record on a 45 degree angle.

Step 7: Remove masking tape hinge in middle of the record and repeat step 6 for opposite side of record.

Step 8: Using firm pressure, squeegee over entire record on a 45 degree angle to secure record to the board.

Step 9: Slowly remove record mask at a 45 degree angle until record is fully visible.  Now present your new record!

Print

Healy Awards – How to Apply Half Helmet Football Helmet Decals

Did you recently order Half Helmet Football Decals from Healy Awards?  If so, these easy to read instructions will help when applying your team’s decals to your football helmets.

Step 1: Before peeling the decal off its back liner, cut around the outside of the entire decal (1/4″ around outside printed areas of shape – leaving a clear vinyl border of 1/4″ around the outside).

Step 2: Remove the excess clear vinyl from the inside and outside areas as you apply the decal.

Step 3: Remove a small portion of the back decal liner.

Step 4: Press down a small portion (non-printed area) of the decal to the helmet for position prior to applying.

Step 5: Apply decal from top to bottom removing the liner backing while pressing decal sections into place.  Apply sections a little at a time.

Step 6: Press down the printed decal sections to helmet several times.

Step 7: Cut out any overlapping vent areas or snaps with a razor blade.

Step 8: Repeat steps for opposite side of helmet.

Step 9: You have successfully applied your half helmet decals!

Half Helmet Instructions

%d bloggers like this: